With the increase of service time, the mechanical parts of the crane will inevitably follow tangible wear rules.The cause of the same failure may not be a one-to-one relationship. Therefore, the fault should be carefully analyzed to find out the specific cause and solve it.
The following conditions occur on the crane pulley:
[1] uneven pulley pulley wear;
[2] The pulley mandrel wear amount is 3 to 5% of the nominal diameter;
[3] The pulley does not move;
[4] The pulley is tilted and loose;
[5] Pulley crack or rim break.
[1] uneven pulley pulley wear;
[2] The pulley mandrel wear amount is 3 to 5% of the nominal diameter;
[3] The pulley does not move;
[4] The pulley is tilted and loose;
[5] Pulley crack or rim break.
Processing method
[1] The wear of the wheel groove wall is 1/10 of the original thickness, and the radial wear amount should be replaced when the wire diameter is 1/4;
[2]Strengthen lubrication, overhaul, and need to be replaced if the fault is serious
[3] Loosen the positioning parts on the shaft, or the wire rope jumps for maintenance and replacement.
[4] Overhaul
[5] Replace
[5] Replace
Precaution
[1] Check whether the material is uniform, whether the installation meets the requirements, and whether the rope and the wheel are in good contact;
[2] Regularly check the mandrel and wire rope wear;
[3] Regularly check whether the positioning parts on the shaft are loose and whether the wire ropes are skipped;
[4] Regularly check the wear of the pulley.
[1] Check whether the material is uniform, whether the installation meets the requirements, and whether the rope and the wheel are in good contact;
[2] Regularly check the mandrel and wire rope wear;
[3] Regularly check whether the positioning parts on the shaft are loose and whether the wire ropes are skipped;
[4] Regularly check the wear of the pulley.